Laverda OR600 Atlas ‘Adventure Motorcycle’

With Phil Aynsley


Laverda had quite a history of producing off-road bikes over the years and actually had a lot of input (as development engineers), into the design of BMW’s extremely successful G/S series – so it should come as no surprise that they also took a crack at the large capacity on/off-road market themselves with the introduction of the OR600 Atlas in 1986.

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

An updated version of the 500cc parallel twin (which had in fact been out of production for several years) had a capacity of 571cc and featured lower compression and softer camshafts than the original.

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas

New pistons and bigger valves together with modified heads and barrels were used. In addition strengthened crankcases, helical primary drive gears, a second balance weight and most importantly an oil cooler and larger oil pump were fitted.

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

300 were built in 1986 but subsequent years saw only 60, 40 and 50 made for a total of 450 units. The blue/white Series 2 bikes were produced in ’87 and ’88 with Series 3 being constructed in ’89. Series 3 had a red/white paint job and twin, side-mounted oil coolers.

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

This particular bike is the 1985 prototype and was extensively ridden by Laverda’s sales director, Giulo Frazan and is unrestored. Note that the muffler was not fitted at the time of photography.

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas

Also note that the engine number hasn’t been stamped, which was fairly usual for the company’s prototypes. Additionally the frame number is OR1000 – which is a factory mistake as all their prototypes started at 1001 (and that is the number on the paperwork)!

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas

Power was 50 hp at 7000 rpm which, with a dry weight of 151 kg, gave a top speed of 175 km/h.

Laverda Atlas ORR PA LaverdaOR

Laverda Atlas ORR PA LaverdaOR

Laverda’s OR600 Atlas
Source: MCNews.com.au

Leave a Reply

Your email address will not be published. Required fields are marked *